Jump to Latest Post
Rate Thread
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rotorway Forums › Rotorway General › Modifications & Recommendations v
tail rotor shaft drive in the boom for the RW
tail rotor shaft drive in the boom for the RW
Location: Qld Australia
Certificates: pilot, owner builder
Graeme Smith Offline
Average Contributor
**
Posts: 92
Threads: 22
Joined: Dec 2025
Reputation: 15
#31
Yesterday, 09:14 AM
this is how the TR attach cone is fitted, simply cut of the skin that protrudes past the last bulkhead.
[Image: 20261018-135711.jpg]

[Image: 20261018-140149.jpg]

[Image: 20261018-140514.jpg]

[Image: 20261018-140915.jpg]

[Image: 20261018-140525.jpg]

[Image: 20261018-151359.jpg]
Find
Reply
Location: Qld Australia
Certificates: pilot, owner builder
Graeme Smith Offline
Average Contributor
**
Posts: 92
Threads: 22
Joined: Dec 2025
Reputation: 15
#32
Yesterday, 10:03 AM (Edited Yesterday, 10:09 AM by Graeme Smith.)
here are the parts, there are 4 of us Aussies doing the upgrade
[Image: 20261021-181243.jpg] [Image: 20261021-181227.jpg] [Image: 20261021-181122.jpg] [Image: 20261021-180451.jpg] [Image: 20261021-180445.jpg] [Image: 20261021-180433.jpg] [Image: 20261021-180418.jpg] [Image: 20261021-180039.jpg] [Image: 20261021-180030.jpg]
[Image: 20261018-151359.jpg]
Find
Reply
Location: Wasilla, Alaska
Certificates: A&P, Rotorcraft CPL/CFI
Lyle Swallows Offline
Average Contributor
**
Posts: 128
Threads: 17
Joined: Dec 2025
Reputation: 23
#33
9 hours ago
holy merry christmas!

i see some extra pitch horns 😉
Find
Reply
Location: Qld Australia
Certificates: pilot, owner builder
Graeme Smith Offline
Average Contributor
**
Posts: 92
Threads: 22
Joined: Dec 2025
Reputation: 15
#34
7 hours ago (Edited 7 hours ago by Graeme Smith.)
I told everyone I was getting them made, but I only ordered 4 sets for the 4 RW upgraded TR shaft drives. So no spare opposite hand TR pitch horns Rolleyes
Find
Reply


Forum Jump:


Recently Browsing 1 Guest(s)